Krell Industries KAV400xi manual Remote Control Only, Battery Installation and Removal, Pre Key

Remote Control Only

See Figure 2 on page 6

Battery Installation and Removal

The KAV–400xi remote control uses one CR2025 lithium battery, which is included with the shipment.

To open the battery compartment on the back of the remote control:

1.Place the remote face down on the table.

2.Use your thumbnail or a small jeweler’s or eyeglass screw- driver to move the small switch toward the center of the remote, while using your index fingernail or screwdriver to pull down gently on the slot to the right of the switch. The battery compartment will slide out.

Note	Do not use a knife or other sharp objects to open the battery compart-
	ment; they will scratch the remote control finish.

Notes

Remote Control Only Functions

POWER

3.Place the battery, positive side up, in the battery tray.

4.Slide battery compartment back into the remote until you hear a click.

The remote control is ready for operation.

Replace battery when remote control function becomes intermittent.

Remove battery if the remote control is not used for a long period of time. Battery leakage can damage the remote control.

The KAV–400xi remote control accesses complete power amplifier and preamplifier functions. A description of the functions unique to the KAV–400xi follow:

12 Pre Key

Use this key to activate the KAV–400xi remote to access amplifier commands.

Krell KAV–400xi 9