D. UNPACKING AND ASSEMBLY
1.Openthe box and removethe top layer ofprotective foam. The following items will nowbe visible:
1
1ACpower cord
1Packet containing,~the OwnersReference and warranty
card~i~
Note: If any of these items are not included please con- tact your authorized dealer immediately for assistance. Save all packing materials. If you must ship your
E.BASIC INSTALLATION AND CONNECTIONS
Before you install the
location. This will facilitate a clean,
CAUTION:Whenmaking connections to this component
~
or any other, makesure ttie poweramplifier is OF1 and the preamplifier is in the MUTEor STANDBYmode.
1.Althoughwell shielded, the processor should not be placed in close proximity to
(i.e. PREAMPS,TURNTABLES,TUNERS, etc.)
2.As with any high quality component, ensure that the vent openings in the chassis are i~ree from obstruction,
allowing the processor to dissipate heat created by,!ts highly regulated power supply and high bias class A"
output stage.
3.Run the male end of the ACcord from the processor location to a nearby wall socket. This will be easier to accomplishno, w, as the componentitself is not in the way. Donot plug the ACcord into the wall socket at this time!
dNOTE:While the
advise against any connections through extension cords or multiple ACadaptors. High quality 15 ampgrounded ACstrips are acceptable.
3