EOPERATION
1.Plug the processor's ACcord into the wall socket.
2.Turn ONyour digital signal source. Whether it is CD, DATor Satellite is not important. The following should occur in this particular sequence¯
A. The two LED'sddgignating Dig.ital and Analog power will illuminate simultaneously. Ttiis is your assurance that the individual power supplies are dperating and stable.
B. After a period of 5 to 20 seconds the digital input circuits will stabilize and the LEDindicating the input source frequency will be illuminated.
,,N, OT,E:The input source componentmust be turned ON'in order for the processor to indicate the input
source frequency.
CAUTION:Should you have any major deviation from this sequence do not attempt to play the unit. Disconnect it prior to powering up any other componentsand contact your Krell dealer immediately.
3.Be sure that your preamplifier's volumecontrol is completely turned to the OFF(lowest volume) position.
4.Turn ONyour components, remembering that the last
componentto be energized should be your amplifier. The amplifier should only be turned ONafter all other com-
po.nents in the system have been on for at least two (2) minutes.
5.Switch the Input selector of your preampto the po.si- tion correlating to your choseninput connection for tlae
6.Youmaynowstart playing your DAT,CDor satellite.
7.Slowl), turn the volumecontrol up to the lowest level you can near. Check to see that both channels are work- ing correctly before advancing the volume.
5
