Assembly
The machine must not be plugged in and the power switch must be in the OFF position until assembly is complete.
Tools Required for Assembly
Item Description
Phillips Screwdriver
Adjustable or 13mm Wrench
Unpacking and Clean-up
1.Carefully finish removing all contents from shipping carton. Compare contents of the shipping carton with the list shown on page 5. Place parts on a protected surface.
2.Report any shipping damage to your local distributor. If parts are missing contact RIKON customer service at
3.Clean all rust protected surfaces. Do not use; gasoline, paint thinner, mineral spirits, etc. These may damage painted surfaces.
4.Set packing material and shipping carton to the side. Do not discard until machine has been set up and is running properly.
1.Install the column to the base using the three column mounting bolts. (Fig.01)
Fig.01
2.Next install the table lock handle through the unthreaded hole on the left of the table support casting. The handle should engage the thread on the right side of the table support casting. (Fig.02)
Fig.02
7
