Assembly
6.The feed handle (A-Fig.06) is secured to the feed shaft with the supplied Allen bolt (B-Fig.06).
B
A
Fig.06
Adjustments
7.Depth Stop: The depth stop and scale are found on the left side of the switch box. To adjust, lower the drill chuck until pointer shows desired depth on the scale. Loosen the lower nut on the threaded shaft (A-Fig.07) until it bottoms out on the head casting (B-Fig.07). Tighten upper nut against the lower nut to retain the adjustment.
8.Table Tilt: The drill press table will tilt 0-45 degrees left and right. To tilt, loosen the nut located under the table (A-Fig.08). Align the
“zero” mark on the table (B-Fig.08) to the desired degree marking on the scale. Tighten the nut under the table to retain the adjustment.
A
B
Fig.07
A 
B 
