Kuhn Rikon 30-100 owner manual Assembly

Assembly

3.Slide the drill press head over the column. (Fig.03)

4.Center the drill press head over the table and base. Tighten the drill press head into position by locking the two hex screws on the side of the casting. (A-Fig.04)

5.Next, slide the 1/2” chuck (A-Fig.05) over the pre-installed spindle (B-Fig.05). Open the chuck jaws fully and tap into place using a rubber mallet or a hammer and block of wood.

Fig.03

A

Fig.04

B

A

Fig.05

8