Kuppersbusch USA IGVS669 manual Cycle Completion Signal, Accomodaling Extra Tall Items

SlPECIAL FEATURES

Cycle Completion Signal

1.Open door, hold down "Delay Start Hours" button and simultaneously turn dishwasher on.

2.The displaywill blinkwith a code of '0'; '1"or '2".

3.Releasethe buttons. You are in program mode. I f the display blinks with a '0;

-you will hear no signal (indicates OFF). I f the display blinks with a '1;

you will hear a LOW volume signal. If the display blinks with a 'Y,

you will hear a HIGHER volume signal.

4.To change program code, press the "Delay Start Hours" button.

5.When you have the desired code selected, turn the dishwasher off to take it out of program mode.

At the end of a wash cycle, the beeper will sound off two times, and again every 15 nin-

until the clishwasher isturned

Accomodaling

Extra Tall Items

I f you have extra tall items that cannot fit in the bottom rack without interfering with the upper spray arm or without hitting the top rack (max, height 22"), you can removethe upper rack. A special accessory, the Extra Tall Item Sprinkler, lets you run the dish- washer with top rack removed: See Figures 31 and 32.

Installing "Extra Pall

Item Sprinkler"

1.With top rack empty, remove it from the dish- washer by pulling the rack toward you to the point where you can lift it up and out, dis- engaging the wheels from the side rails.

2.Place the "Extra Tall Item Sprinkler" over the top rack spray outlet at the back of the dish- washer tub and turn it clockwise to lock the sprinkler head in place. See Figure 32.

3.Place the extra tall items in the bottom rack for washing, as shown in Figure 31. To remove the Extra Tall Item Sprinkler, turn it counterclockwise and pull it out. Then replace the top rack.

Figure 31

Nate: Bs $$areka semo~eWe E&ra Tall Xtem Sprinkler be- f o eyou r 4 3 f m e l i &e tags, rack,

athewise%hed a ~ co~tfdr be-

came elantaged and not close

praperliy.

-- - - * - - -

Figure 32

ENGLISH - 3.7