Kustom GROOVE 1200 GROOVE Specifications, Rack Mounting Instructions, Input Impedance, Footswitch

GROOVE 1200

Specifications

Input Impedance	200K Ohm
Output Power	450 Watts	8 Ohms @ 5%	THD
	750 Watts	4 Ohms @ 5%	THD
	1200 Watts	2 Ohms @ 5%	THD
Frequency Response	20HZ-20kHz	Actual response is tailored to speakers for accurate acoustical
		response using a bass guitar as input.
Hum & Noise	-60db	Residual Noise, all level controls 0% (minimum)
System Gain	27db	Preamp output
	15db	Preamp output, Active
All measurements taken with 1 KHz	25db	Tuner output
	27db	Direct output
input signal, Tone controls flat, Gain and
	32db	Power amp gain
Volume Max imum. Measured at effects
send output jacks on rear unless noted.
Amplifier Type	Class B	Descrete device Class B amplifier
Footswitch	Any non-momentary two-button foot switch can be used.
	Use any standard tip-ring-sleeve cable
	USA/Canada	120VAC/60Hz,	1500W nominal
	Europe	230VAC/50Hz,	1500W nominal
Power Requirements	UK	230VAC/50Hz,	1500W nominal
	Australia	240VAC/50Hz,	1500W nominal
	Japan	100VAC/50-60Hz, 1500W nominal
Dimensions	mm/kg	89 (Height) x 483 (Width) x 390 (Depth), 14 kg
	Inches/Pounds	3.5 (Height) x 19 (Width) x 15.5 (Depth), 31 lbs

Rack Mounting Instructions

The GROOVE 1200 was designed to mount into a standard 2-space rack. When mounting, use 4 screws to secure the amplifier to the rack. When using only one amplifier, use the bottom 2 spaces in the rack. However, if more than one amplifier is used, leave one space open between the amplifiers to ensure proper ventilation (shown below).

9