Kustom GROOVE 600TM owner manual Rack Mounting Instructions, GROOVE Specifications, Dimensions

GROOVE 600™

Specifications

Model

Input Impedance

Output Power

Frequency Response

Hum & Noise

System Gain

All measurements taken with 1 KHz input signal, Tone controls flat, Gain and Volume Maximum. Measured at effects send output jacks on rear unless noted.

Amplifier Type

Footswitch

Power Requirements

Dimensions

Groove 600HD	Bass guitar amplifier
200K Ohm
275 Watts	8 Ohms @ 1% THD
450 Watts	4 Ohms @ 1% THD
600 Watts	2 Ohms @ 1% THD
20HZ-20kHz	Actual response is tailored to speakers for accurate acoustical
	response using a bass guitar as input.
-60dB	Residual Noise, all level controls 0% (minimum)
27dB	Preamp output
15dB	Preamp output, Gain switch set to -12dB
25dB	Tuner output
27dB	Direct output
29dB	Power amp gain
Class B	Descrete device Class B amplifier

KAC-GFS100 recommended, but any non-momentary two-button foot switch can be used.

Use any standard tip-ring-sleeve 1/4" cable

USA/Canada	120VAC/60Hz, 800W nominal
Europe	230VAC/50Hz, 800W nominal
UK	230VAC/50Hz, 800W nominal
Australia	240VAC/50Hz, 800W nominal
Japan	100VAC/50-60Hz, 800W nominal
mm/kg	89 (Height) x 483 (Width) x 390 (Depth), 12 kg
Inches/Pounds	3.5 (Height) x 19 (Width) x 15.5 (Depth), 26 lbs

Rack Mounting Instructions

The GROOVE 600™ was designed to mount into a standard 2-space rack. When mounting, use 4 screws to secure the amplifier to the rack. When using only one amplifier, use the bottom 2 spaces in the rack. However, if more than one amplifier is used, leave one space open between the amplifiers to ensure proper ventilation (shown below).

			9-BAND ACTIVE EQ
-12 dB	FLAT	FLAT	FLAT
NORM
			9-BAND ACTIVE EQ
-12 dB	FLAT	FLAT	FLAT
NORM

9