Kyocera K322 manual Standard Battery

Radio Frequency (RF) energy

Your telephone is a radio transmitter and receiver. When it is on, it receives and sends out RF energy. Your service provider’s network controls the power of the RF signal. This power level can range from 0.006 to 0.6 watts.

In August 1996, the U.S. Federal Communications Commission (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless phones. These guidelines are consistent with the safety standards previously set by both U.S. and international standards bodies in the

following reports:

•ANSI C95.1 (American National Standards Institute, 1992)

•NCRP Report 86 (National Council on Radiation Protection and Measurements, 1986)

•ICNIRP (International Commission on Non-Ionizing Radiation Protection, 1996)

Your phone complies with the standards set by these reports and the FCC guidelines.

E911 mandates

Where service is available, this handset complies with the Phase I and Phase II E911 Mandates issued by the FCC.

Battery and charger specifications

Charger	Input	Output
CV90-G2968-01	120VAC 60Hz 7W	5.2VDC 400mA
CV90-G2588-01	100-240VAC 50/60Hz 0.2A	4.2VDC 0.6A
CV90-G2589-01	100-240VAC 50/60Hz 0.3A	4.5VDC 1.2A

Standard Battery:

CV90-P3031-01 3.7V 900mAh

Extended Battery:

CV90-P3032-03 1800mAh

Kyocera Wireless Corp.

10300 Campus Point Drive, San Diego, CA 92121

U.S.A.

Visit us at www.kyocera-wireless.com

User Guide for the Kyocera K322 Phone v