8
o Time and Indoor Temperature: alternate every 5 seconds (default)
o Time: Hold and release PROJECTION button
Note: Both Time and Indoor Temperature will not show at the same time
Projection Arm Rotation: The projection arm can be rotated 180 degrees to view the
projection on the wall or ceiling.
Backlight Intensity
Press and release the SNOOZE/LIGHT button to adjust the brightness of the backlight:
A/C Power
The backlight is displayed constantly unless turned off.
ON High intensity: The backlight is defaulted to HI when the Adapter is in use.
ON Low intensity: Press and release SNOOZE/LIGHT button once
OFF: Press and release SNOOZE/LIGHT button
ON: Press and release SNOOZE/LIGHT button again
Note: When the Adapter is NOT in use, the High/Low/On/Off features are not available.
Battery Power
Press the SNOOZE/LIGHT button to display the backlight for 10 seconds.
USB Charge Port
The integrated USB charging port (on back) will charge your smart phone, camera or other device when
the Projection Alarm is plugged into a power outlet.
Note: This is a power output (charging) port only. This port will not supply power to the Projection Alarm.
Connect your existing USB charging cord for your external device to the USB c harging port on the
back of the Projection Alarm to begin to charge. Charging times will vary.
Note: Check that your device will charge with the USB cord it came with. Many USB cords are
for data transfer only, and cannot be used for charging.
Output: 0.5A maximum current USB.
Do NOT overload USB port.
IMPORTANT: When operating on a/c power, the backlight, projection and USB charging port will turn off
while the Projection Alarm searches for the WWVB signal, to avoid interference. The backlight and
projection will return after the 2-10 minute search (which occurs during the late night or early morning
hours). Then the USB charging port will resume working.
Moon Phase
The eight phases of the moon shown below are determined by the year, month, and date set on the
Atomic Projection Alarm.
New Moon occurs when the moon is between the earth and sun so the illuminated portion of the moon is
on the back side facing the sun and we cannot see it. After a new moon the illuminated portion will
increase or wax until the full moon occurs.