La Crosse Technology WS-7075U instruction manual Weather Station

back into its hole, and angle it slightly—so the threads grab the battery cover. With the screw, pull the battery cover off.

3.Observing the correct polarity install 2 AAA batteries. The batteries will fit tightly (to avoid start-up problems make sure they do not spring free).

4.Check the LCD screen of the Remote Control Sender to see if there is a temperature reading. If there is no reading, check the polarity of the batteries or replace with new batteries.

5.Check to make sure that the rubber weather-seal is in place, and replace the battery cover, screw, and mounting bracket.

B. WEATHER STATION

1.Remove the battery cover. To do this, insert a solid object in the space provided at the lower-central position of the battery cover, then push up and pull out on the battery cover.

2.Observe the correct polarity, and install 2 AA batteries.

3.Replace the battery cover.

Battery Cover

Note: Immediately after the batteries have been installed, each LCD (Liquid Crystal Display) will flash, and a tone will sound. Within a few seconds the indoor temperature, indoor relative humidity, and the weather icons (sun and clouds) will be displayed. If not, then remove batteries for 10 seconds and reinstall. If the outdoor temperature is not displayed within four minutes, remove batteries from both units, wait 10 seconds, and reinstall. The time will show -:-- and start searching for the signal. If it successfully receives the time signal (usually at night), it will display the correct time (default is Eastern).

5