RDV4136 Series Direct Vent Gas Fireplace

1/2” Gas Supply

1/2” NPT X 1/2” Flare Shut-off Valve

3/8” Flex line (from valve)

FP297A

Fig. 5 Typical gas supply installation.

Always check for gas leaks with a mild soap and water solution. Do not use an open flame for leak testing.

The gas control is equipped with a captured screw type pressure test point, therefore it is not necessary to pro- vide a 1/8” test point up stream of the control.

When using copper or flex connector use only approved fittings. Always provide a union when using black iron pipe so that the gas line can be easily disconnected for burner or fan servicing . See gas specifications for pres- sure details and ratings.

The fireplace valve must not be subjected to any test pressures exceeding 1/2 psi. Isolate or disconnect this or any other gas appliance control from the gas line when pressure testing.

Remote ON/OFF Switch

Installation: RN/RP Models

1.Thread the wiring through holes on the end panels of appliance. Take care not to cut wire or insulation on metal edges. Route the wire to a conveniently located receptacle box.

2.Attach the wire to the ON/OFF switch and install the switch into the receptacle box.

3.Connect the other ends of the wire to the gas control valve. (Fig. 6)

Remote ON/OFF Switch or Thermostat or Remote Control

TP

Gas Control

TH

Valve

TP

 

TH

 

 

FP1224

Fig. 6 Remote switch wiring diagram for RN/RP models.

Remote ON/OFF Switch

Installation: IN/IP Models

1.Thread the wiring through holes on the end panels of appliance. Take care not to cut wire or insulation on metal edges. Route the wire to a conveniently located receptacle box.

2.Attach the wire to the ON/OFF switch and install the switch into the receptacle box.

3.Connect the two (2) wires from wall switch to the two (2) brown wires from the control module marked SW1. Be sure to move the Remote/Off switch on the control module to the OFF position. (Fig. 7)

NOTE: The remote does not work in this configu- ration.

Remote

Switch

SW1

SW1

FP1832

Fig. 7 Remote switch wiring for IN/IP models.

8

10010618

Page 8
Image 8
Majestic Appliances RDV4136 Remote ON/OFF Switch, Installation RN/RP Models, Installation IN/IP Models