Majestic Appliances RDV4136 Optional Accessories, Fan Kits, Hard direct Wire Hook Up, 10010618

RDV4136 Series Direct Vent Gas Fireplace

Optional Accessories

Fan Kits

Installation of the fan kit is best completed prior to installing the fireplace. If done after the fireplace is installed, all lava rocks must be fully removed so the

burner tray can be easily lifted out.

Fan Assembly

Heat SensorFan

	�
��	����
��	�
	���
���

Electrical Box

1.	Remove valve access panel.
2.	Turn OFF the electricity and turn OFF the manual
	gas valve.
3.	Remove the glass door.
4.	Remove the log set, embers and lava rock.
5.	Remove the rear log support.
6.	Remove the 10 sheet metal screws and two (2) 1/4-
	20 bolts that secure the burner tray to the combus-
	tion casing.
7.	Remove the burner tray from the fireplace by first tilt-
	ing up the back. Take care not to damage the formed
	burner tray gasket. If the gasket is damaged, replace
	it with Part # 10010592.
8.	While holding the burner tray, remove the flex gas
	line from the shut-off valve (turned OFF in Step 2).

Fan Speed	Gas Line	Valve	FP1811
Switch

Fig. 58 FK24 fan placement.

Hard (direct) Wire Hook Up

First connect ground wire to ground stud located on the base of either box. Black wire from supply should connect to the variable speed switch. Alternate speed switch wire connects to temperature sensor. Alternate lead from sensor connects to fan. Alternate fan lead connects back to the white supply wire. (Fig. 59)

Any electrical rewiring of this fan must be completed by a qualified electrician.

Turn off all power before hook up.

9. FK12: Fig. 57

Secure fan to cold air box and plug fan into EB-1.

Reassemble fireplace in reverse order. Use a 50/50

soap and water solution to check for leaks.

Side View Cold Air Box

Temperature

Sensor

Speed

Control

Black

White

Ground

Fig. 59 FK24 fan wiring.

Fan

FP1025

Front of

Unit

Hearth Pan

FK12 Fan

Base Pan

FP1004

Fig. 57 FK12 Fan Kit placement.

FK24: Fig. 58

Secure fan to cold air box with two (2) washers and nuts provided. Secure the fan speed switch with two

(2)nuts provided to the two (2) studs on the base

pan of the fireplace. Lay the burner tray upside down in front of the fireplace. Secure the heat sensor over the two (2) studs on the underside of the burner tray assembly and secure with two (2) nuts provided. Re- assemble the fireplace in reverse order. Use a 50/50 soap and water solution to check for gas leaks.

Fan installation complete.

Wiring Instructions

The fireplace, when installed, must be electrically connected and grounded in accordance with local codes or, in the absence of local codes, with the current CSA C22.1 Canadian Electric Code.

For USA installations follow the local codes and the national electrical code ANSI/NFPA No. 70.

Should this fan require servicing or repair the power supply must be disconnected. For rewiring of any replacement parts refer to Figure 59.

Any electrical re-wiring of this fan must be done by a licensed electrician.

10010618 37