Majestic Appliances RDV4136 Locating Your Fireplace, Clearance to Combustibles, Mantels, 10010618

RDV4136 Series Direct Vent Gas Fireplace

Locating Your Fireplace

E	A		B
Y
		C	X
D
Y			B
	F

Fig. 2 Locate gas fireplace.

A - Flat on wall	B - Cross corner	C - **Island
D - *Room divider	E - *Flat on wall corner	F - Chase installation
Y - 6” minimum

Note (Fig. 2):

**Island (C) and Room Divider (D) installation is possible as long as the horizontal portion of the vent system (X) does not exceed 20’ (6m). See details in manual Venting Section.

* When you install your fireplace in(D) Room divider or (E) Flat on wall corner positions (Y), a minimum of 6” (152mm) clearance must be maintained from the perpendicular wall and the front side edge of the fireplace. See (Y) in Fig. 2.

Clearance to Combustibles

Top of Unit to Ceiling	36” (914 mm)
Appliance	0” (0 mm)
Top
Bottom	0” (0 mm)
Side	0” (0 mm)
Back	0” (0 mm)
Venting
Concentric sections of DV..............................Vent	1” (25 mm)
Top, bottom & sides
Offset sections.......................................................of DV Vent	2” (51 mm)
Top
Bottom & sides	1” (25 mm)

Mantels

The height that a combustible mantel is fitted above the fireplace is dependent on the depth of the mantel. This also applies to the distance between the mantel leg (if fitted) and the fireplace.

For the correct mounting height and widths refer to Figures 3a and 3b.

The fitting of a bay window trim kit does not effect the distances and reference points referred to in the diagram and chart.

Noncombustible mantels and legs may be installed at any height and width around the appliance.

When using paint or lacquer to finish the mantel, such paint or lacquer must be heat resistant to prevent discoloration.

6

V
W
X	Noncombstible Material
Y
Z	Framing Members
	Standoff

A B C D E

Top of Combustion

Chamber

			Fireplace
		Mantel Chart					CFM146
	Mantel Shelf			Mantel from Top
Ref.	or Breast Plate		Ref.	of Comb. Chamber
		Depth
V	10”	(254 mm)	A	19”			(483 mm)
W	8”	(203 mm)	B	17”			(432 mm)
X	6”	(152 mm)	C	15”			(381 mm)
Y	4”	(101 mm)	D	13”			(330 mm)
Z	2”	(51 mm)	E	11”			(279 mm)
Fig. 3a	Combustible mantel minimum installation.
	Black				J	I	H G
	Surround
	Face		Mantel				F
			Leg
	Side of				MLK
	Combustion Chamber			N
				O
							CFM170
		Mantel	Mantel Leg FromSide
Ref.	Leg Depth		Ref.	of Comb. Opening
F	10”	(254 mm)	K	11¹⁄₂”	(292 mm)
G	8”	(203 mm)	L	9¹⁄₂”	(241 mm)
H	6”	(152 mm)	M	7¹⁄₂”	(191 mm)
I	4”	(101 mm)	N	5¹⁄₂”	(140 mm)
J	2”	(51 mm)	O	3¹⁄₂”	(89 mm)
Fig. 3b	Combustible mantel leg minimum installation.
							10010618