La Crosse Technology WS-9075U I. The Remote Temperature Sensor, A. Mounting With Screws

MOUNTING

Note: Before permanently mounting ensure that the indoor weather station is able to receive WWVB signals from the desired location. Also, extreme and sudden changes in temperature will decrease the accuracy of the indoor weather station, and changes in elevation will result with inaccurate weather forecasting for the next 12 to 24 hours. These changes will require a 12 to 24 hour wait before obtaining reliable data. To achieve a true temperature reading, avoid mounting where direct sunlight can reach the remote temperature sensor or indoor weather station. While the remote temperature sensor is weather proof, avoid submersion in water or snow. We recommend that you mount the remote temperature sensor on an outside North-facing wall. The sending range is 330ft—obstacles such as walls, concrete, and large metal objects can reduce the range. Place both units in their desired location, and wait approximately 15 minutes before permanently mounting to ensure that there is proper reception. The indoor weather station should display a temperature in the OUTDOOR LCD within 4 minutes of setting up.

I. THE REMOTE TEMPERATURE SENSOR

The remote temperature sensor can be mounted in two ways:

•with the use of screws, or

•using the adhesive tape.

A. MOUNTING WITH SCREWS

1)Remove the mounting bracket from the remote temperature sensor.

2)Place the mounting bracket over the desired location. Through the three screw holes of the bracket, mark the mounting surface with a pencil.

3)Where marked, start the screw holes into mounting surface.

4)Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket.

B.MOUNTING WITH ADHESIVE TAPE

1)With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat.

2)Remove the protective strip from one side of the tape. Adhere the tape to the designated area on the back of the mounting bracket.

3)Remove the protective strip from the other side of the tape. Position the remote temperature sensor in the desired location, ensuring that the indoor temperature station can receive the signal.

I.THE INDOOR WEATHER STATION

The indoor weather station can be mounted in several ways:

•With the use of screws

• Using its foldout stand

A.MOUNTING WITH SCREWS

1)Fix a screw (not included) into the desired wall, leaving approximately 3/16 of an inch (5mm) extended from the wall.

2)Place the indoor weather station onto the screw using the hanging hole on the backside.

3)Gently pull the indoor weather station down to lock the screw into place.

15