II. | DETAILED | battery cover |
A.BATTERY INSTALLATION
1.Remove the battery cover on the backside of the projection alarm.
2.Observe the correct polarity, and install 2 AA
batteries.
3.In addition to or instead of installing batteries,
the AC adapter can be used. Simply plug the adapter into the receptacle on the underneath side of the alarm clock, and then plug in the adapter.
4.Replace the battery cover.
5.The projector will activate and remain on if the alarm clock is plugged in. If only batteries are used, the projector will only be activated when a button is pressed. The projection is a red light, not harmful under normal usage, although care should be taken to not look directly into the light.
Notes:
•After the batteries have been installed, the LCD will activate, and you will hear a beep.
•The indoor temperature will be displayed, and the time will appear as “12:00 AM”.
•The WWVB search is automatically initiated, and a tower icon appears and flashes with the time colon (no tower icon will appear if the WWVB is too weak to be detected, and the time display will start from 12:00 AM).
•While the WWVB search is being conducted various numbers will appear in the time display.
•After 15 minutes, the projection alarm will either display the WWVB time, or discontinue the search if the time is not found. If the search is cancelled the time will continue from 12:00 AM.
•The projection alarm will conduct a WWVB search every hour until the first signal is found.
•Once the WWVB time is found, a search is automatically conducted nightly at midnight.
•If the signal is found at midnight, the tower icon will remain, if not, another search will take place every hour (until 6:00 AM) until the signal is found successfully.
•If no signal is found during this period, the tower icon will not appear, and the clock will search again at midnight the next night.
•The
5
