5.The transmitter should not be mounted on a metal surface.
6.The transmitter and projection alarm should be kept away from other sources of possible interference including cordless appliances (telephones, baby monitors), microwave ovens, and other strong electrical appliances.
7.The remote temperature is displayed in °F or °C, depending on the time format (12 or
G.Time Alarm
The projection alarm has two separate alarms for time, “ALM1” and “ALM2”. The alarms have a different sound; “ALM1” increases in volume after 25 seconds, and again after 50 seconds. “ALM2” is a constant volume. The total duration is 96 seconds for each alarm.
1.Setting the Alarm
a.Press and hold “ALM1” or “ALM2” for two seconds until the alarm time is flashing.
b.Press and release “ALM1/HOUR” to advance the hour and “ALM2/MIN” to advance the minute. The time will display “PM” if set to PM and nothing if set to AM.
c.The projection alarm will revert to normal operation when no buttons are pressed for 15 seconds.
Alarm 2 activated
2.Activating/Deactivating the Alarm
a.After entering the
b.To toggle between activating and deactivating the alarm press either the “ALM1” or “ALM2” buttons briefly. “(((1)))” or “(((2)))” will be displayed to the right of the time display when the alarm is activated.
c.When the snooze bar is pressed the display will scroll through the alarm 1 and alarm 2 times in the lower left.
3.Turning the Alarm Off (While Sounding)
a.While either alarm is sounding press and release the “SNOOZE” bar to disable the alarm for the set duration (See Section II. D.). If the duration is set to “0” the alarm will be disabled for 24 hours.
b.After the “SNOOZE” bar is pressed the lower left will display the time remaining on the snooze. The “SNOOZE” bar may be pressed at any time to restart the snooze duration.
11
