Land Pride 309-502M Support Stand, Cutting Unit

DM35 Series (S/N253045+) Disc Mowers 309-502M 7/18/08

Land Pride

Table of Contents

7. Assemblethe front tarp frame (#29) and rear tar p

frame(#30) to the suppor t frame(#1) using bolts (#31)

and nuts (#32) to secure.

8. Assemblethe shield (#33) to the suppor t frame(#1)

and support leg (#5) using the carriage bolts (#34)

and nuts (#35) to secure.

Support Stand

Refer to Figure 1-4:

Insert stand (#1) into tube on the hitch as shown and

secure with pin (#2) and hair pin cotter (#3).

Support Stand

Figure 1-4

17895

Cutting Unit

Refer to Figure 1-3:

1. Installthe support frame (#1) to the gearbox using the

bolts (#2) and washers (#3).

2. Assemblethe suppor t leg (#5) to the support frame

(#1) using the bolts (#6) and washers (#7). Assemble

the support leg (#5) to the cutting unit (#4) and secure

with bolt (#8) and lock nut (#9).

3. Assemblethe clevis (#11) on the support frame lug

and retain with pin (#12) as shown.Loosen nut on D-

ring (#10) that is at the end of the spring stretcher and

install on the clevis (#11).

4. Installthe cylinder bracket (#13) on to the support

frame(#1) using the pin (#14) and hair pin cotter (#15)

to secure. Assemble the other end of the cylinder

(#16) to the cylinder bracket(#13) and secure with pin

(#14) and hair pin cotter (#15).

5. Attachthe shield (#17) as shown using the brackets

(#19) and (#22). Secure with bolts (#18), washers

(#21) and nuts (#20).

6. Assemblethe guide (#23) to the cutting unit (#4) with

the bolt (#24), washer (#25), ﬂat washer (#27) and

lock nut (#28). Place the spring (#26) between the

guide(#23) and ﬂat washer (#27).Attach the guide rod

(#40) to the guide (#23) with the carriage bolts (#41),

washers (#43) and lock nuts (#42).

17878

Cutting Unit

Figure 1-3