Land Pride 309-502M - page 23

21

Section 4 Maintenance and Lubrication

7/18/08 DM35 Series (S/N253045+) Disc Mowers 309-502M

Land Pride Table of Contents

Cutter Bar

Check oil levelin the cutter bar by removing the ﬁller level

plug. With cutter bar in transport position, use a 5/16” or

8mm allen wrench to remove plug. (The plug is located

betweenthe ﬁrst and second discs on DM3506 and between

the second and third discs on DM3507.) If the oil levelis low,

add oil.

Typeof Lubrication: SAE 80 GL4 (EP) gear lube

Quantity =ﬁll until level with in ﬁller levelplug hole.

NOTE: Do not overﬁll. Mower should be level and

cutter bar vertical when checking oil. Be sure to let

cutting bar set in vertical position for a few minutes

before checking to allow time for oil to ﬂow to the

bottom of bar.

As

Required

Frame Pivot Point

Typeof Lubrication: Grease

20

15154

17897

Hitch Pivot Point

Typeof Lubrication: Grease

20

17897

Contents

Main ! DM35 Series (S/N253045+) Operators Manual Copyright 2008 Printed 309-502M Page 1 Important Safety Information ! ! Be Aware of Signal Words For Your Protection ! Shutdown and Storage Transport Machinery Safely Use Safety Lights and Devices Practice Safe Maintenance Tractors With Cabs Tractors Equipped With ROPS Prepare for Emergencies Tire Safety Wear Protective Equipment Safety at All Times Safety Labels 818-540C 818-552C Page Page Introduction Owner Assistance Serial Number Plate Further Assistance Land Pride Application Tools Required Assembly Preparation Cutter Bar and Gearbox Lubrication Page Section 1 Assembly and Set-Up Support Stand Cutting Unit Attaching the Tractor Transporting Operating Check List Working Position Operating Checklist Mowing Instructions Operating Instructions Section 3 Adjustments Leveling for Transport and Operation Belt Tension Adjustment Section 3 Adjustments Cutting Height General Maintenance Servicing Blades Cutter Bar Timing Adjustment Storage Lubrication Legend Lubrication Page 22 Section 5 Specications and Capacities Section 5 Specifications and Capacities DM35 Series Disc Mowers DM3506 DM3507 Section 7 Troubleshooting 24 Section 8 Appendix Section 8 Appendix Torque Values Chart For Common Bolt Size 5.8 8.8 10.9 Bolt Head Identification Bolt Size (Metric) Bolt Head Identification Bolt Size (Inches) Section 8 Appendix Warranty