Land Pride
Assembly Instructions
Gearbox Assembly
Refer to Figure 7 on page 4:
1.Assemble right angle gearbox (#12) to mounting bracket (#2) with four
Tighten cap screws to 17 ft. lbs. of torque.
2.Attach gearbox mounting bracket (#2) to the newly drilled 11/32" holes in the engine mounting plate (#1) with two
3.Reassemble front drive shaft (#11) and 3/16" x 7/8" key (#3) to the gearbox. Do not tighten 3/8" hex head cap screw (#6).
4.Reassemble gearbox (#12) and 3/16" sq. key (#4) to gearbox coupler (#14). Torque
5.Torque 3/8" hex head cap screw (#6) to 49 ft. lbs.
6.Torque the two hex nylock nuts (#8A) to 17 ft. lbs.
7.While holding gearbox mounting bracket (#13) tight against the transmission support bracket (#16), tighten the four
8.Center punch the center of the two slots in mounting bracket (#13).
9.Drill 1/8" pilot holes in the transmission support bracket (#16) at the center punch marks. Be careful not to drill through the transmission housing.
10.Redrill the pilot holes to 11/32" diameter. Be careful not to drill through the transmission housing.
11.Attach bracket (#13) to transmission support (#16):
•NT Trekers:
a.Install two 5/16" x 3/4" lg. hex head cap screws (#5B & 5C), flat washers (#9B) and hex head nylock nuts (#8B). Torque nuts to 17 ft. lbs.
•ST Trekers:
a.Install
b.Remove 5/16" muffler mounting hardware (#17, 18
&19) on the left side of vehicle only. Discard bolt #17.
c.Attach support bracket (#15) to the under side of transmission support (#16) with new
d.Insert
e.Tighten nuts (#8B & #19) to 17 ft. lbs. of torque.
Refer to Figure 1 & Figure 2 on page 1:
12.Reinstall existing shock with
13.Lower vehicle to the ground and remove wheel chocks.
23681
Gearbox Removal (Muffler Not shown For Clarity)
Figure 7
4 | Manual No. | ■ 6/14/05 |