Table of Contents
Section 1: Assembly &
Land Pride
Mud Scraper Installation (Optional)
Optional mud scrapers are available from your local Land Pride dealer. A scraper bundle consists of one rear roller scraper and two front roller scrapers and are identified by the rear roller type and seeder planting width.
| Land Pride Mud Scrapers |
Part No. | Part Description |
|
|
APS1548 |
|
SPIKE SCRAPER BUNDLE . . . S/N 567003+ | |
PACKER SCRAPER BUNDLE . S/N 567003+ | |
APS1560 |
|
SPIKE SCRAPER BUNDLE | |
PACKER SCRAPER BUNDLE | |
APS1572 |
|
SPIKE SCRAPER BUNDLE. . . . S/N 547969+ | |
PACKER SCRAPER BUNDLE . . S/N 547969+ | |
APS1586 |
|
SPIKE SCRAPER BUNDLE | |
PACKER SCRAPER BUNDLE | |
|
|
Refer to “Torque Values Chart For Common Bolt Size” on page 28 when tightening hardware.
Front Mud Scrapers
Refer to Figure
IMPORTANT: Some units will not accept a Mud Scraper attachment. Please be sure of your serial number to verify.
NOTE: Do not tighten bolts (#4 & #5) until after adjustments have been made. See “Mud Scraper Adjustment (Optional)” on page 14 for instructions.
1.Attach spike scrapers (#3) to scraper hangers (#2) with
2.Attach scraper hangers (#2) to the front rollers with four
Rear Mud Scraper
Refer to Figure 1-5 on page 9:
The instructions below apply to both the rear packer roller and rear spike roller.
1.Lower rear roller to ground level to compress spring (#6). Adjust
2.Support seeder frame at this height to keep seeder frame from creeping lower during assembly.
3.Shut tractor engine off and engage parking brake.
4.Attach vice grips tightly to the spring rod and tight against the spring rod guide bar to retain spring compression.
5.Loosen bearing set collar screw (#2) and remove lock nut (#3), cap screws (#4) and lock washers (#5). Keep hardware for reuse.
| vel |
| ra |
| DirectionT |
| of |
Left Hand Roller | Right hand Roller |
| 25607 |
Front Mud Scraper Installation
Figure
8 | APS1548, APS1560, APS1572 & APS1586 All Purpose Seeder | 5/13/08 |