Land Pride APS1560 Special Instructions For Spike Roller, Table of Contents, Assembly & Set-up

Table of Contents

Section 1: Assembly & Set-up

Land Pride

Special Instructions For Spike Roller

Refer to Figure 1-7:

NOTE: Do not tighten bolts (#11 & #18) until after adjustments have been made. See “Mud Scraper Adjustment (Optional)” on page 14 for instructions.

1.Attach spike scrapers (#17) to scraper hanger (#9) with 3/8"-16 x 1 1/4" GR5 round head square neck bolts (#18) and hex flange lock nuts (#19). Draw nuts up snug, do not tighten until after completing adjustments in Section 3.

2.Attach scraper hangers (#9) to chain guard

mount (#7) with two 3/8"-16 x 1 1/4" GR5 hex head cap screws (#11), 3/8" flat washers (#15) and 3/8" lock washers (#16). Secure scraper in place with hex nuts (#13). Draw nuts up snug, do not tighten until after completing adjustments in Section 3.

3.Attach opposite end to scraper mount (#10) with two 3/8"-16 x 1 1/4" GR5 hex head cap screws (#11), 3/8" flat washers (#15) and 3/8" lock washers (#16). Secure cap screws with hex nuts (#13). Draw nuts up snug, do not tighten until after completing adjustments in Section 3.

25606

Rear Mud Scraper Installation to Spike Roller

Figure 1-7

10 APS1548, APS1560, APS1572 & APS1586 All Purpose Seeder 313-354M 5/13/08