Land Pride | Table of Contents |
Section 2: Operating Instructions
Operating Check List
Hazard control and accident prevention are dependent upon the awareness, concern, prudence and proper training involved in the operation, transport, maintenance and storage of the seeder. Therefore, it is absolutely essential that no one operates the All Purpose Seeder without first having read, fully understood and become totally familiar with the Operator’s Manual. Make sure the operator has paid particular attention to:
•Important Safety Information, pages 1 to 5
•Section 1: Assembly & Set-up, page 7
•Section 2: Operating Instructions, page 11
•Section 3: Adjustments, page 14
•Section 4: Maintenance & Lubrication, page 22
The following information should be known and inspections made before operating your seeder.
4.Attach tractor’s top center link to the seeder’s top hitch using a 3/4” diameter hitch pin. Secure hitch pin with a linch pin.
5.Ensure that the lower hitch arms are blocked to prevent excessive side movement.
6.Return to tractor and slowly operate controls up and down to make sure seeder clears tractor tires, frame and drawbar. Move or remove drawbar if it interferes.
7.Manually adjust one of the tractor’s lower lift arms up or down to level the seeder from left to right.
8.With the seeder resting on level ground, manually adjust tractor’s top link until the seeder is level from front to rear.
Transporting
!CAUTION
Check | Reference |
|
|
Read and follow all “Safety Rules” | Important Safety |
carefully. | Information |
Read and follow “Tractor | Section 2 |
instructions below. | page 11 |
Read and understand “Operating and | Operator’s |
Adjustment Instructions” in this manual | Manual |
Lubricate seeder as needed. Refer to | Section 4 |
“Lubrication” | page 23 |
Check seeder initially and periodically for | Section 8 |
loose bolts & pins, “Torque Values Chart”. | page 28 |
Make sure all guards and shields are in | Operator’s |
place. | Manual |
|
|
Check initially and periodically for loose bolts, | Operator’ |
pins, and chains. | Manual |
Inspect seed cups and seed tubes for foreign | Section 3 |
matter. | page 17 |
Set speed change sprocket for drive type | Section 3 |
desired. | page 16 |
Set seed rate. See “Seed Rate Charts”. | Section 3 |
| pages 18 to 21 |
|
|
Tractor Hook-up
!DANGER
Tractor
1.Slowly back tractor up to the All Purpose Seeder while using the tractor’s
2.Engage tractor park brake, shut tractor engine off and remove key before dismounting from tractor.
3.Attach tractor’s
When traveling on public roads whether at night or during the day, use accessory lights and devices for adequate warning to operators of other vehicles. Comply with all federal, state and local laws.
1.This seeder can be transported with a full box of seed, however; it is best not to do this unless necessary because the increased weight does increase the chances for problems on the road.
2.Select a safe ground travel speed when transporting from one area to another. Do not exceed 20 miles per hour travel speed. When traveling on roadways, transport in such a way that faster moving vehicles may pass you safely.
3.Reduce tractor ground speed when turning. Leave enough clearance so the seeder does not contact obstacles such as buildings, trees or fences.
4.Shift tractor to a lower gear when traveling over rough or hilly terrain.
Filling the Seed Box
!CAUTION
Always lower the All Purpose Seeder to the ground before filling and checking seed level in the seed box. This will keep the rollers from turning while working around them.
Refer to Figure 2-1 on page 12:
1.Always lower the All Purpose Seeder to the ground, engage tractor park brake, shut tractor engine off and remove key before filling the seed box.
2.Release lid latch handle (#5) and open seed box lid (#1) until over center latch arms (#2) have locked in place. Doing this will keep the lid from falling while filling the box.
3.Fill seed box from the rear while standing on the ground. Do not step or climb on the rear roller (#3) to fill the seed box. Make sure the rear roller (#3) is on the ground so it cannot turn while filling the box.
5/13/08 | APS1548, APS1560, APS1572 & APS1586 All Purpose Seeder | 11 |