Land Pride APS1548, APS1560 Special Instructions For Packer Roller, Refer to -6below & -7on page

Land Pride Table of Contents

Section 1: Assembly & Set-up

24977	Attach a vice grip tightly to	Spring Rod
	the spring rod at this location.

5

Spring Rod

Guide Bar

	6
	1
3	2
	4

Important: Make sure there is space between the roller arm (#1) and stop blocks above and below the arm and that the arm is not tight against a stop block before attaching a vice grip to the spring rod.

Roller Arm Disassembly Position

Figure 1-5

Refer to Figure 1-6 below & Figure 1-7 on page 10:

6.Pull roller arm assembly (#1) away from rear roller end plate and insert two 1/2"-13 x 1 1/2" GR5 hex cap screws (#12) from the inside as shown.

7.Reinstall roller arm assembly (#1) to the seeder side plate with existing 3/4"-10 hex flange lock

nut (#3), 5/8"-11 GR5 hex head cap screws (#4) and lock washers (#5). Torque all hardware including bearing set collar screw (#2).

8.Remove vice grip from spring rod.

9.Attach left hand scraper mount (#10) to the left side roller arm (#1) with hex flange lock nuts (#14). Tighten lock nuts (#14) to the correct torque.

Special Instructions For Packer Roller

Refer to Figure 1-6:

NOTE: Do not tighten bolts (#16) until after adjustments have been made. See “Mud Scraper Adjustment (Optional)” on page 14 for instructions.

1.Attach rear roller scraper (#9) to chain guard mount (#7) with two 3/8"-16 x 1 1/4" GR5 hex head cap screws (#11), 3/8" flat washers (#15), 3/8" lock washers (#16) and hex nuts (#13). Draw nuts up snug, do not tighten until after completing adjustments in Section 3.

2.Attach opposite end to scraper mount (#10) with two 3/8"-16 x 1 1/4" GR5 hex head cap screws (#11), 3/8" flat washers (#15), 3/8" lock washers (#16) and hex nuts (#13). Draw nuts up snug, do not tighten until after completing adjustments in Section 3.

25605

Rear Mud Scraper Installation to Packer Roller

Figure 1-6

5/13/08 APS1548, APS1560, APS1572 & APS1586 All Purpose Seeder 313-354M 9