Table of Contents
Section 1: Assembly and
Cutter Bar Assembly
Refer to Figure
2.Attach outside material guide (#3) to cutter assembly with 1/2” x 3 1/2” grade 5 hex head bolt (#8), 1” dia. x 2” compression spring (#15), flat washer (#12), and nylock nut (#11) as shown. Tighten locknut to compress spring (#15) only enough to retard guide movement.
3.Assembly front curtain support frame (#1) to curtain support beam (#6) with three 3/8” x 2 1/2 grade 5 hex bolts (#9) as shown. Secure with hex nylock nuts
(#10) and tighten to a loose fit. Insert three 3/8” x
2 1/8” clevis pins (#14) through the support arms as shown and secure with 1/8” cotter hair pin (#13).
4.Assembly rear curtain support frame (#2) to curtain support beam (#6) with six 3/8” x 2 1/2” grade 5 hex bolts (#9). Secure with hex nylock nuts (#10) and tighten to correct torque.
5.Do not attach end bumpers (#7) to curtain support frames until instructions for “Canvas Curtain Assembly” on page 12 are completed.
21023
Figure
10 DM3705, DM3706, and DM3707 Series Disc Mowers | 9/15/06 |