![As](/images/new-backgrounds/88954/8895451x1.webp)
Table of Contents
Section 4: Maintenance and Lubrication
20772
As
Required
Cutter Bar
Check oil level in cutter bar by removing filler level plug with cutter bar in transport position. (Fill/Level plug is located between first and second discs on DM3705 and between second and third discs on DM3706 and DM3707.) Add oil if level is low.
IMPORTANT: The recommended oil quantity should not be exceeded. Results of overfilling will be overheating with potential for severe damage to cutterbar. Mower should be level and cutter bar vertical when checking oil. Be sure to let cutting bar set in vertical position for a few minutes before checking to allow time for oil to flow to bottom of bar.
Type of Lubrication: SAE 90 GL4 (EP) gear lube
Quantity = Fill until level with filler level plug hole. (See important note above.)
21032 |
20
Hours
Frame Pivot Point
Type of Lubrication:
|
| 20 |
|
| Hours |
|
| Hitch Pivot Point |
|
| Type of Lubrication: |
| 21032 |
|
24 | DM3705, DM3706, and DM3707 Series Disc Mowers | 9/15/06 |