Land Pride | Table of Contents |
Section 2: Options, Assembly & Set-Up
Gauge Wheel
Kit Bundles
Refer to Figure 2-5:
1.Attach gauge wheel mounting bracket (#11) to Rear Blade frame with two
2.Insert gauge wheel hitch tube (#9) in gauge wheel arm (#3).
3.Attach gauge wheel arm (#3) to mounting bracket (#11) with
4.Insert gauge wheel caster assembly (single wheel caster #1) or (dual wheel caster #2) in gauge wheel arm (#3) and retainer washer (#4). Secure caster assembly with 1/2” x 2 1/2” long roll pin (#5).
5.Attach center floating link (#12) to the front hitch with 1 1/4” x 1 3/4” hitch pin (#7). Secure with hair pin cotter (#6).
Ratchet Jack Option
1.Attach ratchet jack (#19) to the mounting lugs on the gauge wheel arm (#3) and mounting bracket (#11) with two 1" clevis pins (#20). Secure pins with hair pin cotters (#21).
Hydraulic Cylinder Option
1.Position hydraulic cylinder (#15) with ports on top as shown. Thread 90 degree elbows (#13) into the two ports and tighten.
2.Screw 123" long hydraulic hoses (#14) to the elbows and tighten.
3.Thread hydraulic couplings (#18) (couplings provided by customer) to the other end of hydraulic hoses and tighten.
IMPORTANT: Assemble base end of cylinder to the front lug on the mounting bracket (#11) as shown.
4.Attach hydraulic cylinder to the lugs on the gauge wheel with two 1" clevis pins (#17). Make sure hydraulic ports are positioned on top and cylinder base is located to the front as shown.
5.Secure clevis pins with hair pin cotters (#16).
6.Route the hoses through the hose brackets located on the top of the main frame and right side of the front hitch. Connect hoses to tractor's hydraulic system.
25505 |
Gauge Wheel Assembly
Figure
5/21/07 | RBT55120 Rear Blades | 13 |
