Land Pride RBT55120 Manual Offset, Angling and Tilting, Manual Blade Angling, Manual Blade Offset

Table of Contents

Section 2: Options, Assembly & Set-Up

Land Pride

Manual Offset, Angling and Tilting

The manual links and ratchet jack may be used in place of the hydraulic cylinders.

IMPORTANT: Do not remove shipping block from the blade tilt housing until all cylinders and/or ratchet jack and manual links have been installed.

Manual Blade Angling

Manual Blade Offset

Refer to Figure 2-4:

9.Attach blade offset links (#3 and #4) to the left side of the Rear Blade as shown with two 1" clevis pins (#1). Secure with hair pin cotters (#5).

10.Adjust offset angle by removing hitch pin (#2) and moving outer link (#3) to a different hole. Replace hitch pin and secure with hair pin cotter (#5).

Refer to Figure 2-4:

7.Attach blade angling links (#3 and #4) to the right side of the Rear Blade as shown with two 1" clevis pins (#1). Secure with hair pin cotters (#5).

8.Adjust blade angle by removing hitch pin (#2) and moving outer link (#3) to a different hole. Replace hitch pin and secure with hair pin cotter (#5).

Manual Blade Tilting

Refer to Figure 2-4:

1.Attach ratchet jack (#6) to the back side of the Rear Blade as shown with two 1" clevis pins (#1). Secure with hair pin cotters (#5).

2.Adjust blade tilt by setting the lock on the ratchet lever and pumping the lever back and forth to raise one end of the blade higher than the other end. Reposition ratchet lock and pump lever back and forth to tilt blade in the opposite direction.

3.Remove shipping block after ratchet jack (#6) has been installed.

Blade Offset

Blade Angling

SHIPPING BLOCK

DO NOT REMOVE UNTIL AFTER ALL

HYDRAULIC CYLINDERS AND/OR

RATCHET JACK AND MANUAL LINKS

HAVE BEEN INSTALLED.

Blade Tilting

25508

Manual Offset, Angling and Tilting

Figure 2-4

12 RBT55120 Rear Blades 301-172M 5/21/07