Land Pride RBT55120 Blade Offset Cylinder, Blade Angling Cylinder, Options, Assembly & Set-Up

Table of Contents

Section 2: Options, Assembly & Set-Up

Land Pride

Blade Offset Cylinder

Refer to Figure 2-1:

IMPORTANT: Do not remove shipping block from the blade tilt housing until all cylinders and/or ratchet jack and manual links have been installed.

IMPORTANT: Attach cylinder base to the front hitch lug. The cylinder base will interfere with the main frame if attached to the rear lug.

Assemble the hydraulic hoses to the hydraulic cylinder before placing the cylinder on the blade.

1.Position hydraulic cylinder (#3) with ports on top as shown. Install two straight fittings (#4) into the cylinder ports as shown. Tighten as needed.

2.Screw 116" long hydraulic hoses (#5) into straight fittings (#4) and tighten.

3.Thread adapter fittings (#6) to the other end of the hydraulic hoses and tighten. (Hydraulic couplings not furnished.)

4.Attach hydraulic cylinder to the lugs located on the left side of the 3-Way Rear Blade with clevis pins (#2). Make sure hydraulic ports are positioned on top and the cylinder base in positioned to the front as shown.

5.Secure clevis pins with hair pin cotters (#1).

Blade Angling Cylinder

Refer to Figure 2-2:

IMPORTANT: Do not remove shipping block from the blade tilt housing until all cylinders and/or ratchet jack and manual links have been installed.

IMPORTANT: Attach cylinder base to the front hitch lug. If attached to the rear lug, the base will interfere with the main frame.

1.Position hydraulic cylinder (#3) with ports on top as shown. Install two straight fittings (#4) into the cylinder ports as shown. Tighten as needed.

2.Screw 116" long hydraulic hoses (#5) into straight fittings (#4) and tighten.

3.Thread adapter fittings (#6) to the other end of the hydraulic hoses and tighten. (Hydraulic couplings not furnished.)

4.Attach hydraulic cylinder to the lugs on the right side of the frame with clevis pins (#1). Make sure hydraulic ports are positioned on top and the cylinder base in positioned to the front as shown.

5.Secure clevis pins with hair pin cotters (#2).

6.Route hoses through hose bracket located on the right side of the front hitch. Connect hoses to tractor's hydraulic system.

6.Route hoses through hose bracket located on the right side of the front hitch. Connect hoses to tractor's hydraulic system.

25502

25503

Hydraulic Blade Angling

Figure 2-2

Hydraulic Blade Offsetting

Figure 2-1

10 RBT55120 Rear Blades 301-172M 5/21/07