Toshiba MMU-AP0091H service manual 206, Remarks, Disassembling, Reassembly, Cabinet

16. REPLACING PROCEDURE OF PARTS

No.	Part to be	Work procedure		Remarks
	exchanged
1	Cabinet	REQUIREMENT		Discharge cabinet
		Wear protective clothing on your hands as
			2)
		other components may cause and injury etc.

Disassembling

1) Stop the unit operation and turn off the power supply to the unit.

2)	Remove the screws on the discharge	Screws (4 corners)
	cabinet. (M5 × 16, 4 pcs.)
3)	Remove the screws (Front/rear at lower	5) Suction cabinet
		(Front and rear)
	side) on the cabinet. (M5 × 10, 7 pcs. each)

4)Remove the screws on the service panel. (M5 × 10, 3 pcs.)

5)Remove the screws (Front/rear sides) on

the suction cabinet.
(M5 × 10, 4 pcs. each)
(M4 × 10, 2 pcs. each)
6) Remove the screws (Right/left sides) on the	3) Lower cabinet tab	6) Side board
side panel. (M5 × 10, 4 pcs. each)	(Front and rear)	(Right and left)
	4) Service panel

Reassembly

Reassemble the cabinet in the reverse proce- dure ( 6) → 1) ) on the above “Disassembling Procedure”.

However be sure to follow the following points when assembling the discharge cabinet.

MCautions when assembling the discharge

	cabinet
	The hooking tabs ∗ (6 positions) located on	* Hooking tab
	the inside edge of the discharge cabinet, are		)
		2 × 3 positions each at
	to be correctly fitted into the relevant slots on
		(longitudinal direction
	the right/left side panels.
	Failure to do so may result in unit vibration.
2 Propeller fan	REQUIREMENT
motor

Discharge cabinet

Wear protective clothing on your hands as
other components may cause and injury etc.	2)

Disassembling

1)	Stop the unit operation and turn off the
	power supply to the unit.
2)	Remove the screws on the discharge	Screws (4 corners)
	cabinet. (M5 × 16, 4 pcs.)

206