Assembly Guide

Step 10: ATTACHING THE HYDRAULIC CYLINDERS

Locate the following for this step:

PARTS:

TreadClimber® Base & Treadle Assembly from Step 9.

HARDWARE:

Two (2) 5/16” x 1-1/2” Button Head Screws

Two (2) 5/16” Acorn Nuts

Two (2) 5/16” x 1” Button Head Screws

Two (2) 5/16” Flat Washers

TOOLS:

3/16” Hex Key (included)

9/16” Open End Wrench (included)

10-1First bolt the dial end of the cylinders to the uprights using (1) 5/16" x 1-1/2" button head screw and (1) 5/16" acorn nut, per side.

Tighten with the provided 9/16" open end wrench and 3/16" hex key (see Figure 10-1).

10-2Make sure that the white arrows located on the Workout Level Setting Dials at the top of the Hydraulic Cylinders face the rear of the machine where you can easily see them during your workout.

10-3Starting on the right side, pull the cylinder down and place the eyelet on the Cylinder Stud protruding from the treadles. Attach the hydraulic cylinder using (1) 5/16" x 1" button head screws and (1) 5/16" flat washers (see Figure 10-2).

10-4Repeat this process on the left side.

Note: If having difficulty placing hydraulic cylinder(s) on treadle stud, loosen lower upright screws, place cylinder on the stud and retighten the upright screws.

Figure 10-1

Figure 10-2

Step 11: INSPECTING ASSEMBLY

11-1Remove the protective plastic film from the console face. Inspect all attachments you have made thus far and tighten all bolts securely before proceeding to Step 12.

Bowflex® TreadClimber® Owner’s Manual

20

Page 23
Image 23
Bowflex TC3000, TC5000, TC1000 manual Attaching the Hydraulic Cylinders, Inspecting Assembly