Bowflex TC1000 manual Calibration Process TC3000 and TC5000 only, TC3000 Power & Slower Buttons

Assembly Guide

Step 19: CALIBRATION PROCESS (TC3000 and TC5000 only)

7 ! 2 . ) . '

Failure to calibrate your machine prior to use could result in machine failure and could cause injury.

During the entire calibration process, stand on the side foot support platforms or rubber mat only, do not stand on the walking belts!

DO NOT STEP ON THE BELTS DURING THIS ENTIRE PROCESS.

Owners of the TC3000 or TC5000 will need to calibrate the TreadClimber® machine before they can begin exercising. Owners of the TC1000 do not need to complete this step.

Calibrating the TC3000 and TC5000 is an important part of troubleshooting maintenance.

Note: You will also need to re-calibrate your machine in the event of

a power outage or if you have replaced a TreadClimber® component, such as a belt, or motor.

19-1Plug power cord into wall outlet.

19-2Turn on Main Power Switch (see Figure 19-1).

19-3Stand on the side foot support platforms or rubber floor mat, DO NOT STAND ON THE BELTS.

19-4Insert the Safety Key, press and hold down the POWER button, then very quickly press and hold down the SLOWER button. Continue to hold down the POWER and SLOWER buttons (see Figure 19-2 for the TC5000 and Figure 19-3 for the TC3000).

Note: If the Safety Key is not fully inserted into the safety keyhole, the TreadClimber® machine will NOT power up.

19-5At this point you should see the numbers start to decrease on the console.

19-6While continuing to hold down the POWER and SLOWER buttons, remove and re-insert the Safety Key.

Figure 19-1

Main Power Switch “On”

Figure 19-2

TC5000 Power & Slower Buttons

0/7%2 -/$5,%

É 

4/ 34!24

 0RESSS*"7,



 --

Figure 19-3

TC3000 Power & Slower Buttons

Bowflex® TreadClimber® Owner’s Manual 24