Assembly Guide

Assembly Instructions

Step 1: PLACING TREADLES ON BASE

Locate the following for this step:

PARTS:

TreadClimber® Base Assembly

TreadClimber® Treadle Assembly

HARDWARE:

• Four (4) 3/8” x 1-1/4” Hex Bolts

TOOLS:

9/16” Open End Wrench (included)

Scissors or other cutting tool

1-1Place the latch lever on the base in the unlocked position (see Figure 1-1).

1-2Cut the wire ties on the teeter assembly and extend the teeter to the center of the treadles (see Figure 1-2).

1-3With the help of another, carefully rotate the treadle assembly so the teeter is hanging downward above the base. Slowly lower treadle assembly onto base. Make sure teeter mechanism passes freely through hole in the center of base (see Figure 1-3). Carefully align roller casting so it lays flush on the base (see Figure 1-4). For TC3000 and TC5000 models verify that the step sensor is properly aligned (see Figure 1-3). For all TreadClimber® machines center the treadles, using the orange

ALIGN TO TREADLES

#!,,,  7)4()15%34)/.3

0/52 4/54% 15%34)/. !00%,%: ,%,



ALIGN TO UPRIGHT

BRACKET

TREADLES

Remove before use and follow these directions, “Before BRACKET tightening the bolts on the rear casting, center the treadles

using this card as a guide.”

Retirez avant l'emploi et suivez les ces directions, “Avant serrant les boulon sur le bâti arrière, centrez les pédales en utilisant cette carte comme guide.”

Remove before use and follow these directions, “Before tightening the bolts on the rear casting, center the treadles using this card as a guide.”

Retirez avant l'emploi et suivez les ces directions, “Avant serrant les boulon sur le bâti arrière, centrez les pédales en utilisant cette carte comme guide.”

FF2899

Illustration 1-A

treadle alignment card (see Illustration 1-A), before proceeding.

1-4Using the 9/16" open end wrench, tighten the

(4)3/8" x 1-1/4" hex bolts on the rear roller casting to bring the casting and base snugly together (see Figure 1-5).

Figure 1-1

Figure 1-2

Figure 1-3

Align roller casting so it lays

flush on base

Figure 1-4

Figure 1-5

Bowflex® TreadClimber® Owner’s Manual

14

Page 17
Image 17
Bowflex TC3000, TC5000, TC1000 manual Assembly Instructions, Placing Treadles on Base