Toshiba MMU-AP0091H service manual 214, Assembly

No.	Part to be	Work procedure	Remarks
	exchanged
8 Attachment/		REQUIREMENT	1)
	detachment of
	pipe fixing	Wear protective clothing on your hands as
	rubber	other components may cause and injury
		etc.
		Disassembling
		1) Squeeze the band either side of the clip to	Compress the rubber to release the cup.
		release.	1)

2) Pushing in the tab side of SUS band the tab comes off from square hole.

		Push in the band towards the arrow mark.
Assembly		Align the direction of the slits
1)	Individually fit each rubber bracket to the	and then attach to each pipe.
	relevant pipe.		1)
2)	For assembly align the tab side of the SUS
				1)
	band to the slit side of the rubber bracket.

3)Attach the rubber band so that there is no gap between the SUS band and the the fixing rubber bracket. Pay special attention no to create a gap at the hair pin of the rubber band.

4) Squeeze the rubber bracket and band so		Matching the tabs, the slide them.
	Align the tabs to the slit side of the rubber.
that the hook part of the band clips into the
square hole.	2)

Slide it.

Push the band against the rubber to eliminate any gaps.

3)

Slide the square hole side towards the arrow mark.

4)

Push the tab side up against the rubber.

214