Toshiba MMU-AP0091H service manual High Wall Type Model 1H series, Model 2H series

44

High Wall Type

(Model : 1H series)

•	Push the projection at the center of the air filter.
•	Undo the clip on the air filter, pull the air filter downwards while
	pushing it towards the main unit side.
(Model : 2H series)		Push the air filter,
•	Open the air inlet grille.	and pull it downward.
	Lift the air inlet grille up in to the horizontal position.
•	Take hold of the left and right handles of the air filter and lift it up
	slightly, then pull downwards to remove it from the filter holder.

Filter holder

Floor Standing Cabinet Type

•Gently push down the upper part of the suction port, and then pull towards you to remove it.

• Take out the air filter inside of the suction port.

Floor Standing Concealed Type

• Push down on the hook of the air filter on the front panel (Lower side).

• Pull the air filter towards you to remove it.

Front panel (Lower)

Air filter knob

Floor Standing Type

Removal / Attachment of air filter

Re-installing the air filter

•Insert the upper portion of air filter confirming alignment with the right and left edges of the indoor unit until it is located.

•Close the air inlet grille.

If the FILTER lamp on the indoor unit is lit, push the FILTER button on the remote controller or the TEMPO- RARY button on the indoor unit to turn off the lamp.

Filter holder

Cleaning the air inlet grille

1. Remove the air inlet grille.

Hold the two sides of the air inlet grille and open in an upwards direction.

Move the center arm to the left and remove the grille.

2.Wash it with water using a soft sponge or towel.

(Do not use metallic scrubbing brush or other hard brushes.)

• Use of such hard objects will cause scratches on the surface of the grille, and the metal coating to peel off.

•If very dirty, clean the air inlet grille with a neutral detergent for kitchen use, and rinse it off with water.

3. Wipe the air inlet grille and allow to dry.

4. Fit the left and right arms of the air inlet grille to the shafts on the two sides of the air conditioner and push in completely, then push in the center arm.

5. Check that the center arm has been completely inserted and then close the air inlet grille.

•Push the arrow locations (Four) at the bottom of the air inlet grille to check whether the grill is completely closed.

• Pull the air filter towards you.

•To attach the air filter, insert it into the main body and push.

NOTE

•When cleaning the air filter, use a small brush or cleaning device.

If the air filter is heavily stained use a neutral detergent mixed with warm water.

Cleaning of main unit / remote controller

CAUTION

•Wipe them with a soft and dry cloth.

•A cloth dampened with cold water may be used on the indoor unit if it is very dirty.

•Never use a damp cloth on the main unit or remote controller.

•Do not use or leave a chemically treated duster on the unit for long periods of time, as it may damage or alter the colour of the unit surface.

Thinner

Polishing Benzene powder

Chemical floor-cloth

Do not use.

•After washing the filter, rinse it out thoroughly and place in the shade to dry. Do not expose to direct sun light.

•Once the air filter has dried, place the air filter back into the unit.

•Do not use benzine, thinner, polishing powder, or similar solvents for cleaning. These may cause the plastic surface to crack or deform.