Toshiba MMU-AP0091H service manual 211

No.	Part to be	Work procedure	Remarks
	exchanged
5	Inverter assembly	REQUIREMENT

MRemoval of P.C.

board and			Wear protective clothing on your hands
electric parts			as other components may cause and
			injury etc.
5.	Reactor	1)	Stop operation, and then turn the power
6.	Transformer
			supply to the unit.
7.	Electrolytic	2)	Take off the screws (3 positions) on the
	capacitor		terminal block installation board.
		3)	Take off the fixing screws on each part
			and then remove the cables. ∗	Reactor, transformer and electrolytic
				condenser are stored at the rear side
				of the terminal block.

∗Caution when removing the electrolytic

capacitor (No.7)			2) Screw
1) Electrolytic capacitors will discharge			2) Screw
over time.
As the natural discharge by the electlytic			2) Screw
capacitor may be unavailable and
voltage may remain in some cases due
to trouble conditions, be sure to confirm
discharge of the capacitor.
2) Use a suitable resistive load (100Ω /40W			Terminal block
or equivalent) to discharge the capacitor			installation board
or plug of the soldering iron, make
continuity and discharge between
and	poles.
Recommendation will check the voltage
with a DC volt meter.
NOTE
Do not discharge using a tool (e.g. screw-		5. Reactor	3) Screw
driver) as the capacitor charge can cause
		(2 pieces)
an injury.

3) Screw 6. Transformer

7. Electrolytic condenser

Plug of soldering iron

211