Table of Contents
Section 2: Adjustments
Land Pride
Angling and reversing
Refer to Figure
Eight holes are provided for angling the blade in either the forward or reverse position. The blade can be angled horizontally 45 degrees to each side of center in 15 degree increments.
Blade Tilt
Refer to Figure
Five holes are provided for tilting the blade to either the left or right positions. To tilt the blade pull the hair pin cotter and pin on the mainframe and rotate the blade. Reinsert pins.
12051 |
Blade Angling
Figure
Pitch
The pitch of the blade can be adjusted by lengthening or shortening the top link of the tractor.
12046 |
Blade Tilt
Figure
Blade Offset
Refer to Figure
The blade may be offset 12” right or left by unbolting the moldboard from the blade mount weldment and then rebolting it, using alternative holes provided on the moldboard.
14965 |
Blade Offset
Figure
8 | RBT1560, RBT1572 & RBT1584 Rear Blades | 2/01/07 |