Land Pride | Table of Contents |
Section 1: Assembly & Set-up
RBT15 Rear Blades
Refer to Figure 1-1:
1.Insert the blade assembly (#1) through the hole on the main frame assembly (#2).
2.Place the pivot cap (#3) over the threaded shaft protruding through the opening on the main frame assembly (#2).
3.Thread on slotted hex nut (#4) until the vertical play is removed from pivot.
4.Insert the cotter pin (#5).
5.Line up holes in the mainframe assembly and blade assembly and insert lock pin (#6).
6.Position upper hitch mast (#7) on the main frame (#2) and insert bolts (#8). Retain with lock washers (#9) and hex nuts (#10). Tighten to proper torque.
!CAUTION
Always check to be sure that the slotted hex nut and cotter pin are in place to retain the blade before reversing the blade. If they are missing, the blade will fall off the frame while being rotated!
12015
RBT15
Figure
7.Install support leg (#11) into support stand bracket and secure with 3/8" x 1 3/4" lg. roll pin (#12).
8.Secure the wire pin (#13) in the top hole when storing the blade. Raise the leg all the way up and secure the wire pin in the bottom hole when the blade is attached to a tractor.
3-Point Hook-Up
Refer to Figure
!DANGER
Tractor
1.Slowly back the tractor up to the rear blade and use the tractor’s
!DANGER
Engage parking brake, shut off tractor and remove key before dismounting from the tractor.
2.Slide the lower link arms hitch link holes onto the rear blade hitch pins.
3.Install a linch pin or other fastener (supplied by customer) through the hitch pin hole to lock the lower links into position.
4.Connect the top link to the upper pivot hitch using a clevis pin supplied by the customer.
13809 |
Tractor
Figure
2/01/07 | RBT1560, RBT1572 & RBT1584 Rear Blades | 7 |