ATX Installation and User’s Guide
How to access Setup Modes
1.Select the setup mode to enter by pressing the SET button for the period of time defined in the table below.
2.When the mode changes to the selected setup mode, the functions of the selected mode will flash.
3.Change the values of the functions by pressing UP / DOWN button.
4.Press the SET button to enter selection. When the setup process is complete, it returns to a normal display.
Normal operation resumes if no buttons are pressed for 5 minutes.
SET button | Set mode | |
|
| |
2 seconds or | Time zone set | |
shorter | mode | |
2 – 7 seconds | Manual time set | |
mode. (Do not | ||
| use this feature). | |
7 seconds or | Link set mode* | |
longer | ||
| ||
|
|
Master Set itemRepeater
Time zone, D.S.T | Invalid | |
|
| |
Year, Month / Day, | Year, Month / Day, | |
Hour / Minute | Hour / Minute | |
|
| |
Channel Status, | Channel Status, TX | |
channel, RX Channel, | ||
TX Channel | ||
Layer | ||
| ||
Only display: | Only display: | |
WWVB Elapsed | Linkage Elapsed Time, | |
Time | WWVB Elapsed Time |
*This is an advanced setting that will rarely be required. If you have multiple transceivers and are experiencing synchronization problems please review the document ID #888 – “Some clocks are not correcting to time signals” located on our Knowledge Base at
Page 9