Lathem PC400, PC3500, PC2000, PC100-R, PC2500 manual Badge #253 Set Baud Rate

ENTER BAUD 1ST DIGIT 1200 2400 4800 9600

PC100 Terminal User’s Guide

♦PC100 version number

♦Terminal ID# (ID=49)

♦Percent full memory

(each time you poll the clock, this resets to 0%)

♦Clock ready status (READY/LOAD LIST)

♦Baud Rate

♦12-Hour or 24-Hour time display format

♦Daylight Savings Time (DST) ON/OFF

After a few seconds, the display returns to normal.

Badge #253 – Set Baud Rate

Swipe this badge to change the baud rate – the default is 9600. You may need to reduce the baud rate if you have

problems communicating with the clock. These problems can result from a noisy environment or a long serial cable (usually more than 50 feet).

To change the baud rate, swipe the Set Baud Rate badge, then when prompted, swipe employee badge #1, 2, 4 or 9 to indicate 1200, 2400, 4800 or 9600 baud.

NOTE: RS-485 communications do not support 1200 baud

Badge #254 – Setup Terminal ID

Swipe this badge to change the clock ID – the default ID is 49. When prompted, swipe an employee badge that matches your desired ID. If you have more than one clock, make sure each one has a unique ID number.

8