15
Cleaning the Mower
1.Remove the bag (model 10358 only).
2.With the engine
running on a flat paved surface, spray a stream of water in front of the right rear wheel.
1093
The water will splash into the path of the blade, cleaning out the clippings.
3.When no more clippings come out, stop the water and move the mower to a dry area.
Storage
Store the mower in a cool, clean, dry place.
Folding the Handle
Warning
Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition.
Do not damage the cables when folding or unfolding the handle.
If a cable is damaged, contact an Authorized Service Dealer.
1.Loosen the handle
knobs until you can move the upper handle freely.
Preparing the Mower for Storage
Warning
Gasoline vapors can explode.
Do not store gasoline more than 30 days.
Do not store the mower in an enclosure near an open flame.
Allow the engine to cool before storing it.
1.On the last refueling of the year, add fuel stabilizer to the fuel as directed by the engine manufacturer.
2.Run the mower until the engine stops from running out of fuel.
3.Prime the engine and start it again.
4.Allow the engine to run until it stops. When you can no longer start the engine, it is sufficiently dry.
5.Remove the wire from the spark plug and connect the wire onto the retaining post.
6.Remove the spark plug, add 1 oz. (30 ml) of oil through the spark plug hole, and pull the starter rope slowly several times to distribute oil throughout the cylinder to prevent cylinder corrosion during the
7.Loosely install the spark plug.
8.Tighten all nuts, bolts, and screws.
9.Charge the battery for 72 hours, then unplug the battery charger and store the mower in an unheated area. If you must store the mower in a heated area, you must charge the battery every 90 days.
2.Fold the upper handle forward as shown.
Important: Route the cables to the outside of the handle knobs as you fold the upper handle.
3.To unfold the handle, reverse the steps above.
Removing the Mower from Storage
1.Remove the spark plug and spin the engine rapidly using the starter to blow the excess oil from the cylinder.
2.Install the spark plug and tighten it with a torque wrench to 15
3.Charge the battery (model 10357 only).
4.Connect the wire to the spark plug.
