WIRING DIAGRAM
b) During CD mode:
Press the TOP button briefly to interrupt the playback of the CD.
ANTENNA PLUG
YELLOW FUSE 7A
CONSTANT B+
BLACK(GND)
FUSE 0.5A
ACC RED (B+)
BLUE AUTO ANT
FRONT | + |
| WHITE | |
LEFT |
| - |
| WHITE/BLACK |
|
| |||
SP | + | GREEN | ||
REAR | - |
| GREEN/BLACK | |
Note: |
|
|
|
|
|
| RCA LINE OUT |
|
|
| RED R |
|
|
|
| |||
|
|
|
| + | WHITE L | |
|
|
|
| |||
|
|
|
| |||
|
| GREY | FRONT | |||
|
|
|
|
| - |
|
|
|
|
|
|
| |
|
| GREY/BLACK |
| RIGHT | ||
|
| VIOLET | + | SP | ||
|
|
|
|
| ||
|
| VIOLET/BLACK | - | REAR |
Press again to resume normal playback of the CD.
Press the TOP button and hold for approximately 2 seconds to play the first track of the current disc.
Press the INT button to play the first 10 seconds part of each track. Press again to stop scan, while the currently selected track will be played.
Press the RPT button to play the current track repeatedly. Press again to cancel this function.
Press the RDM button to play all tracks on disc in random. Press again to cancel this function.
16. CLOCK BUTTON
Press the CLK button briefly to display time on the display, then press the CLK button and hold until the real time flashes on the display. And then press the + or - button to adjust HOUR or MINUTE.
17. SCAN BUTTON
Make sure use a speaker with 4 ohm load impedance to reduce the distortion during high volume level.
For connecting speaker harness better and prevent to short circuit, please have connecting refer to the process as follow.
Press the SCN button to scan the radio frequency. If a valid signal has detected, the current frequency will be hold and blinked for 5 seconds, then press SCN again to stop scan and remain the current frequency; otherwise, the radio will go on to scan the other radio frequency fiver seconds later.
18. ST/MO BUTTON
During radio mode, press the ST briefly to select stereo or mono sound mode.
19. INFRARED REMOTE CONTROL SENSOR
7 | 4 |