EN | abnormal use, and before, during and after important | |
measurements. | ||
| ||
| Make sure the Leica DISTO™ optic is kept clean and | |
| that there is no mechanical damage to the bumpers. |
CAUTION:
In using the instrument for distance measure- ments or for positioning moving objects (e.g. cranes, building equipment, platforms, etc.) unforeseen events may cause erroneous measurements.
Precautions:
Only use this product as a measuring sensor, not as a control device. Your system must be configured and operated in such a way, that in case of an erroneous measurement, malfunction of the device or power failure due to installed safety measures (e.g. safety limit switch), it is assured that no damage will occur.
Switching on/off
1x briefly: the instrument and the laser are switched on.
The display shows the battery symbol until the next button is pressed.
Pressing this button for longer switches the instrument off.
The instrument switches off automatically after three minutes of inactivity.
Setting the instrument
Press long until the desired unit is displayed.
Possible units:
| Distance | Area | Volume | |
1. | 0.000 m | 0.000 m² | 0.000 m³ | |
2. | 0'0'' | 1/ | 0.00 ft² | 0.00 ft³ |
|
| 16 |
|
|
3. | 0 in | 1/ | 0.00 ft² | 0.00 ft³ |
|
| 16 |
|
|
4. | 0.00 ft | 0.00 ft² | 0.00 ft³ |
CLEAR-Key
1x briefly: the last action is cancelled.
Illumination
1x briefly: the display illumination is switched on or off.
Reference Setting
Default reference setting is from the rear of the instrument.
The instrument can be set for the following measure- ments:
•To measure from an edge (see drawing {D}), fold out the stop bracket until it snaps in for the first time. See drawing {E}.
•To measure out of a corner (see drawing {D}), fold out the stop bracket until it snaps in, push
Operation
4
Leica DISTO™ D2 762960 en