Lennox Hearth I200 Installing the imprinter

C-2 A-61167 April 2005

Installing the imprinter

Removing the circuit board

cover

1. Make sure that the scanner is powered down and there are no documents

in the feeder area.

2. Disconnect the power cord from the back of the scanner.

3. Disconnect the IEEE-1394 (FireWire) cable from the IEEE-1394 port on

the back of the scanner.

4. Lift up the scanner door release to unlatch the scanner door.

5. Pull up to open the scanner door.

6. Remove the output tray.

7. Lift up the scanner door release again and open the scanner door past the

circuit board cover.

8. Use a Phillips-head screwdriver to remove the two screws (one front, one

back) that hold the circuit board cover inplace.

Circuit board cover

Contents

Main Contents Page Page Introduction Scanner features Paper transport features Speed/Capacity (throughput) Image quality features Maintenance Optional accessories Preparing documents for scanning Recommended documents Safety information Warning labels User precautions Safety and regulatory agency approvals Environmental information Acoustic emission Power system EMC statements United States Japan Taiwa n Peoples Republic of China Installing the Scanner Site specifications System requirements Minimum system configuration Recommended system configuration Unpacking the scanner Registering your scanner Scanner components Front 12 A-61167 April 2005 Rear Side Internal Making connections Power setup Page Page Input and output trays Adjusting the output tray Closing the input and output trays Installing optional accessories Using the Scanner Starting and stopping scanning Automatic feeding Continuous feeding Manual feeding Damaged documents Additional features Long Paper mode Special Document mode Perfect Page with iThresholding Toggle patch Maintenance Cleaning the scanner Page Cleaning the feed module Cleaning the drive rollers and transport area Cleaning the imaging guides Cleaning the paper path Replacing parts Calibrating the scanner Troubleshooting Indicator lights Lamps Clearing document jams Adjusting the separator module tension System is not responding Color image quality Problem solving Page Transporting the scanner Appendix A Specifications Page Appendix B Supplies and Accessories Appendix C Kodak i200 Series Imprinter Contents of the imprinter kit Installing the imprinter Removing the circuit board cover Page Page Page Page Page Completing the imprinter installation Page Installing the ink blotter strips Installing an ink cartridge Page Imprinter maintenance Replacing the ink blotter strips Replacing the ink cartridge carrier Imprinting overview Print characters Imprinter specifications Appendix D Kodak i200 Series Dockable Flatbed Page Using the flatbed Book scanning Calibrating the flatbed Cleaning the flatbed After a power failure Removing the dockable flatbed Page Appendix E Installing Optional Memory Installing memory in the scanner