13. Do not insert or allow foreign objects to |
enter any ventilation or exhaust opening, as |
this may cause an electric shock, fire, or |
damage to the appliance. |
14. To prevent a possible fire, do not block air |
intakes or exhausts in any way. Do not use near |
soft surfaces, like a pillow, where openings |
may become blocked. |
15. This appliance has hot and arcing or spark- |
ing parts inside. Do not use it in areas where |
gasoline, paint or flammable liquids are used or |
stored. This fireplace should not be used as a |
drying rack for clothing, nor should Christmas |
stockings or other decorations be hung near it. |
16. Use this appliance only as described in this |
manual. Any other use is not recommended by |
the manufacturer and may cause a fire, electric |
shock or injury to persons. |
17. Avoid the use of an extension cord be- |
cause the extension cord may overheat and |
cause a risk of fire. However, if you have to |
use an extension cord, the cord shall be No. |
16 AWG minimum size and rated not less |
UNPACKING THE UNIT
Refer to Figure 2 for identification of the components as the product is unpacked.
Be sure to identify all components before proceeding with the installation.
1.Cut the top band of the package assembly and lift the container top off. This top can be used as a clean surface to assemble the televi- sion assembly.
2.Remove the grate (1) and ember bed (2) and dust cover (11), set them aside in a safe place off of the floor.
3.Discard the corrugated support (3) and lift out the log package (4). Set it with the grate and ember bed. Remove the door rail and grille cover (12) and set it aside.
4.A panel of glass (5) is located in the front of the carton wrapper. Lift the glass panel out and set it with the logs. All of these items will be installed in the final phase.
5.Cut the bottom band and remove the car- ton wrapper (6). The wrapper can be used as a working surface in front of the installation opening.
6.Remove the Television support tray (7) from the unit. Place it on the carton top for assembly shortly.
7.Remove the television box (8) from inside the unit and set it near the support tray. Re- move the side refractory panels (13).
8.Remove and discard the protector pad (9).
9.Lift the unit (10) off of the carton bottom and set it in front of the framed opening on the carton wrapper. Discard the bottom cap.
All of the components numbered should be identified before proceeding. Order information for any missing components can be found in the replacement parts list on page 12.
than 2025 Watts. The extension cord must |
be a three wire cord with grounding type plug |
and cord connection. |
18. SAVE THESE INSTRUCTIONS. |
LOCATING YOUR REFLECTIONSTM ELECTRIC FIREPLACE
Your new fireplace may be installed into existing framing. It may also be built into a wall, see Figure 3, or set in a freestanding mantle available from your dealer (see Figure 12 ).
When choosing a location for your new fire- place, ensure that the general instructions are followed. Also, for the best effect, install the fireplace out of direct sunlight and away from overhead lighting.
Figure 1
TYPICAL PACKAGING
2
11
4
3
12
13
8
7
5
Figure 2
Carton Top
1
6
10
9
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. | 3 |