Lennox Hearth MP04-VDLE, MN04-VDLE Lighting Instructions Electronic, What to do if YOU Smell GAS

Lighting Instructions — Electronic

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY

RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.

A. When lighting the appliance, follow these instructions exactly.

B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Extinguish any open flame.

•Open windows.

•Do not light any appliance.

•Do not touch any electrical switches.

•Do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone.

•If your gas supplier cannot be reached, call the fire department.

C.Use only your hand to turn the gas control lever. Never use tools. If the lever will not turn by hand, do not try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or an explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

		LIGHTING INSTRUCTIONS
1.	STOP! Read the safety information above on this page.		6. Push the unit mounted "ON/OFF" switch back to the "ON"
2.	Turn remote wall switch to “OFF" or set wall thermostat		position. (The "ON/OFF" switch may include a wall switch
			if so equipped). Replace the batteries in the battery
	to lowest setting. If used, remove the batteries from the		holder, if used. If the burner does not light or stay lit after
	battery holder.		several tries, turn the unit mounted "ON/OFF" switch to
3.	This appliance is equipped with an ignition device which		the "OFF" position and call your service technician or gas
			supplier. NOTE: Sufficient time must be allowed for air to
	automatically lights the pilot. Do not try to light the pilot
			escape from lines if the unit is being lit for the first time.
	by hand.
4.	Push the unit mounted "ON/OFF" switch to the "OFF" posi-		7. Turn HI-LO burner control knob to desired setting and
			close control door.
	tion.

		IN
	TH TP
TP	LO	HI	PILOT
	TH	OUT	IN
		VENT

5.Allow sufficient length of time (minimum 5 minutes) for any gas in the combustion chamber to escape. If you still smell gas, STOP! Follow “B” in the safety informa- tion above on this page. If you do not smell gas, go to the next step.

8.Set thermostat to desired setting if applicable.

9.If the appliance will not operate, follow the instructions "To Turn Off Gas To Appliance" and call your service tech- nician or gas supplier.

To shut off

1.Turn off all electrical power to the appliance (remote wall switch) or set the thermostat to the lowest setting, if ap- plicable. Or remove batteries, if used.

14

TO TURN OFF GAS TO APPLIANCE

1. For complete shut-down, turn remote wall switch to “OFF"	3. Turn off all electric power to the appliance and remove
or set the thermostat to the lowest setting, if applicable.	backup batteries if service is to be performed or for
	extended shutdown.

2.Turn the ON/OFF switch to “OFF”. If step 1 is not applicable.