8
2. Slide on the side pieces ensuring that the grille fixing holes (shown)
are aligned towards the top of the glass facia (as shown in figure 11).
3.Ensure the sides are neatly aligned with the glass and secure the
sides using two M6 screws for each side as shown in figure 12. Do
not overtighten the screws.
4. Position the grille within the two side pieces ensuring a neat fit.
5. Secure the grille in position using two M6 screws and two no. 8 self
tapping screws as shown in figure 14.
The glass facia panel is supported by four M6 screws which protrude
from the front of the outer casing. Insert the M6 retaining screws and
ensure they are unscrewed approximately 1/8” so the keyhole shaped
holes may engage, and the facia can be hooked on. Ensuring that the
corresponding keyhole shaped holes engage the screwheads fully.
Refer to figure 15.
Remove the two side panel
assemblies from the protective
packaging and fit onto the sides of the
firebox as shown. Insert the M6
retaining screws in the sides of the
firebox and ensure they are
unscrewed approximately 1/8” so the
keyhole shaped holes may engage,
and the sides can be hooked on.
16.0 FITTING THEGLASS FACIA15.0 ASSEMBLYOF THE GLASS FACIA - (continued)
Grille fixing holes
Figure 11
Figure 12
TOP
Figure 13
Figure 14
Figure 15
17.0 FITTING THE SIDE PANELS
Note : Front frame/facia not shown
for clarity.
Figure 16