INSTALLATION
Wall Sleeve Assembly
To assemble the wall sleeve, refer to the followinginstruc- tions and Figure 1.
1.Slide top panel over side panels until retaining clips are engaged in slottedopenings.
2_ Place side and top assembly down with the front flange against floor and slide bottom panel into side panel slip strips untiltabs on bottom panels are locked in place.
3.Attach squaring braces to top and side panels using existingholes. (Do not remove braces until wall sleeve is secured to building.)
4.
8.
Attach the support angles to top and side panels using the #8 x 318"screws provided.Two sets of holes are provided in the panels for attaching the support angles. Use the row of holes nearest the front of the sleeve to attach the support angles for 1"spacing or the second set of holes for
The wall sleeve must be square in opening before securing sleeve to building. This is required to assure the
Caulk all seams where the bottom panel joins to the side panels includingthe front corners of the bottom panel and the top of side panel slipjoints. Caulk sealing is best accomplished after the wall sleeve is assembled but before Ris placed in the wall opening. Remaining final caulk sealing can be done just after the sleeve is secured intothe wall opening, if desired, to avoid breakingthe seal during handling.
Wall Sleeve Assembly
TopPanel
P/N 33021B000
Frontof
Squaring | Left Side Panel P/N 33024B001 |
Braces |
|
P/N33048B000 |
|
RightSide Panel P/N 33024B002-
Side SupportAngle PIN 33027BG00 - 2 Side=
Figure I
