c.Touch only the edges of the microprocessor. Do not touch the gold contacts on the bottom.
d.Do not drop anything onto the microprocessor socket while it is exposed. The socket pins must be kept as clean as possible.
8.Ensure that the small handle is in the raised position.
9.Remove the protective cover that protects the gold contacts of the new microprocessor.
10.Hold the new microprocessor by its sides and align the small triangle on one corner of the new microprocessor with the corresponding small triangle on one corner of the microprocessor socket.
11.Lower the new microprocessor straight down into the microprocessor socket on the system board.
12.Lower the small handle to secure the new microprocessor in the socket.
13.Reinstall the heat sink and fan assembly. See “Replacing the heat sink and fan assembly” on page 49.
14.Reconnect all cables that were disconnected from the system board.
What to do next:
•To work with another piece of hardware, go to the appropriate section.
•To complete the replacement, go to “Completing the parts replacement” on page 79.
Replacing the primary hard disk drive
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information” on page v.
This section provides instructions on how to replace the primary hard disk drive.
Note: Depending on your model type, your computer might come with a
To replace the primary hard disk drive, do the following:
1.Turn off the computer and disconnect all power cords from electrical outlets.
2.Remove the computer cover. See “Removing the computer cover” on page 34.
3.Locate the primary hard disk drive. See “Locating internal drives” on page 14.
4.Disconnect the signal cable and the power cable from the hard disk drive.
5.Pull the blue handle to release and remove the hard disk drive from the drive cage.
Chapter 5. Installing or replacing hardware 53
